Knowledge base · General engineering
TRACTOR PTO ADAPTERS- SNAP HITCH SPLINED ADAPTERS
Provisions must be made by the user to shield any exposed driveline components. Shorten implement driveline or extend hitch point to accommodate the application of these devices.
Stock No.
A Female
B Male
Function
Wt. Lbs.
Rec. HP
Add to Cart
120-0621
1-3/8 x 6
1-3/8 x 21
1-3/8 x 6 to 1-3/8 x 21
3.56
29
120-2106
1-3/8 x 21
1-3/8 x 6
1-3/8 x 21 to 1-3/8 x 6
3.37
29
NOTE: EXCEEDING RECOMMENDED HP will VOID WARRANTY
Technical context from YJMT
PTO shafts, adapters and guarding
The text above is an archived manufacturer announcement. The notes below are ours: general guidance on this class of equipment, with no specification attributed to any named product.
Standards that must match
Agricultural power take-off is standardised, and the standards are not interchangeable. The common combinations are a 6-spline shaft at 540 rpm and a 21-spline shaft at 1000 rpm; 20-spline and 8-spline variants exist on specific machines. An adapter lets an implement built for one specification run on a tractor with the other — but changing the spline does not change the speed.
That is the point people get wrong. Driving a 540 rpm implement at 1000 rpm overspeeds every rotating part in it. Confirm both the spline and the shaft speed before coupling, and set the tractor to the speed the implement requires.
Length and travel
A telescoping driveshaft must keep sufficient overlap at full extension and must not bottom out at full compression. Get this wrong and the shaft either pulls apart under load or, worse, jacks the tractor and implement apart at the hitch. Check through the full range of movement, including at maximum articulation and full lift.
Guarding is not optional
An unguarded rotating PTO shaft is among the most dangerous things on a farm or site. It turns fast enough that clothing caught in it gives no chance of escape, and the injuries are catastrophic. The guard cones on the tractor and implement, the shaft guard tube, and the restraining chains that stop the guard rotating with the shaft are one system — all of it must be present and intact.
Never step over a rotating shaft, and stop the engine before approaching any coupling.
Sourcing desk
Need the machine, not just the theory?
Send the specification and destination port. You get a factory-direct price, lead time and shipping estimate within two business days.