Knowledge base · Grinding & milling
Rod Mills
Rod mills are able to accept feeds up to approximately 2”, depending on the hardness of the material. in most cases, an ideal rod mill feed will be minus ¾” with about 80% passing ½”. Rod mills are used to produce products with maximum sizes from 4 mesh to as fine as 35 mesh. the rods in a rod mill are in line contact and as a result preferentially grind the largest size particles and produce a product which has a relatively narrow range of size distribution; i.e., very little tramp oversize and very little extreme fines.
Figure 1 shows the various types of rod mill discharge arrangements. Overflow discharge is most common and is used extensively in mining applications. the grinding is done wet and the mill is used to reduce a crushing plan product to a size suitable for ball mill feed.
In practice it has been proven that rod mill design is subject to several limitations. the ratio of length to diameter should not be less than 1.2/1. the speed at which the mill is operated should be limited to a maximum of 70% of critical speed and preferably should be in the 60 to 68 percent critical speed range.
Sourcing desk
Need the machine, not just the theory?
Send the specification and destination port. You get a factory-direct price, lead time and shipping estimate within two business days.