Knowledge base · Mining & minerals
Cylinder Finishers
Photo: Hydraulic cylinder by S.J. de Waard · CC BY 2.5 via Wikimedia Commons
GOMACO Corporation pioneered the cylinder finisher concept more than 45 years ago. the late Harold W. Godbersen, the founder of GOMACO Corporation, developed and manufactured a bridge deck finisher to meet the growing needs for bridge markets. Considered to be a milestone, the cylinder finisher made GOMACO a recognized name in the construction industry.
Technical context from YJMT
How a cylinder finisher differs from a vibrating screed
The text above is an archived manufacturer announcement. The notes below are ours: general guidance on this class of equipment, with no specification attributed to any named product.
The mechanism
A cylinder finisher finishes fresh concrete with a rotating cylinder that travels across the slab, turning against the direction of travel. The rotating drum shears the surface and carries excess material forward rather than pressing it down. That distinction matters: a vibrating screed consolidates and strikes off, whereas a cylinder finisher produces a tightly closed, flat surface with much less operator dependency.
Where it is used
Bridge decks are the classic application, because deck concrete must meet a tight surface tolerance across a wide span with reinforcement close to the surface. Canal linings, flat slabs and some airfield work use the same principle. The machine typically rides on rails or on the deck screed rails, so the finished profile follows the rail rather than the operator's arm.
Specification points
- Span. The frame must cross the full pour width, and frame deflection over that span directly becomes surface tolerance.
- Rail setting. Almost every complaint about a finisher's flatness turns out to be rail setting, support spacing or rail deflection, not the machine.
- Cylinder condition. A worn, dented or out-of-round drum leaves a repeating pattern that no amount of passes will remove.
- Travel speed against concrete workability. Too fast leaves an open surface, too slow overworks it and brings up laitance.
Concrete has a working window. The finisher must be set up, tested and ready before the pour starts, not adjusted while the slab stiffens.
Sourcing desk
Need the machine, not just the theory?
Send the specification and destination port. You get a factory-direct price, lead time and shipping estimate within two business days.